Finished printing and have started assembling this model. I'm planning to use the FT Aura 5 with a Spectrum remote receiver and small, conventional form factor 2.5g servos. I was thinking about using a hot knife to cut ~ 20x8 mm mounting holes with approximate locations marked by blue tape in the attached photo. I'd reinforce the opening with a small PLA mount. (The black lines mark the CF tubes I need to avoid.) Wondering what you think about this approach?
Thanks, Jon. 10-4 on the weight distribution. Will watch that carefully and report back.
Hi Jeffrey, it looks like a sound approach to me. You may not need the carbon reinforcement so I would do that second. Any weight you are adding would do better forward rather than aft. Please share how you get on using those electronics.