I bought the portor and I went to print the tail end on my ender 3v2 and it's telling my that the tail end is too tall. my table it 220x220x250 can some one help me with how to fix this so I can print this airplan?
Thank you for the Quick response. Is there anyway that I can the the exact size of each part so I can insure they are printing right. When I open them in Cura it seams they are much larger then should be. The rear fuselage was 265MM.
Hi Ronald, it should fit without a problem with a 250mm Z height. Make sure the part is sitting flat to the print bed with the “lay flat” command. If that still doesn’t work let me know and I will send you another part.
thank you very much
Hi Ronald, So I measured the part in Fusion and... You were right, although it didn't come out at 265mm but it was 1.27mm too big.
I have re-sliced the components and will send you up to date download links.
Thank you for the Quick response. Is there anyway that I can the the exact size of each part so I can insure they are printing right. When I open them in Cura it seams they are much larger then should be. The rear fuselage was 265MM.
Hi Ronald, it should fit without a problem with a 250mm Z height. Make sure the part is sitting flat to the print bed with the “lay flat” command. If that still doesn’t work let me know and I will send you another part.