Hi, Are there any Snapmaker (A250) owners trying to print Dragon or any other model ?
. I'm just looking for the best Cura settings. I haven't started to print anything yet, but if someone could give me any hints (I would like to use LW-PLA). This is my second model, I have printed Fouga Magister (downloaded from another site). Only mistake I made there was to print using too low temperature (LW-PLA).
Hi Jukka, I would use the print settings from your other build as a starting point and tweak them for the Dragon settings in the printing manual. Temps etc should stay the same but infill may be different. Jon